Everclear 2-component colour adhesive, beige Art. 12968
The weather-resistant Everclear 2-component colour adhesive is ideally suited for a permanent bonding of large-area, light-coloured ceramics or hard stone on the outside. The creamy soft consistency also makes it suitable for vertical bonding of visible joints. There will be no discoloration afterwards!
Properties:
- colour: beige
- for indoor and outdoor use
- enables the use for vertical bonding of visible joints
- virtually non-yellowing
- excellent adhesion
- fast surface drying
- weather-resistant
- UV-stable
- wide adhesive joint gap possible
- solvent-free
The filler-containing 2-component colour adhesive can be processed very well due to its soft, stable consistency. The cartridge system ensures easy dosing and mixing. Thanks to the low shrinkage, there is only minimal tension in the adhesive layer. Due to its weather resistance and UV stability, Everclear 2-component colour adhesive is ideal for outdoor use.
You can choose from thirteen different colours for colour-matched bonding:
- Everclear 2-component colour adhesive, white Art. 12965
- Everclear 2-component colour adhesive, white Art. 12966
- Everclear 2-component colour adhesive, cream Art. 12967
- Everclear 2-component colour adhesive, beige Art. 12968
- Everclear 2-component colour adhesive, grey Art. 12969
- Everclear 2-component colour adhesive, black Art. 12974
- Everclear 2-component colour adhesive, grey Art. 12996
- Everclear 2-component colour adhesive, grey Art. 12998
- Everclear 2-component colour adhesive, grey Art. 12999
- Everclear 2-component colour adhesive, khaki Art. 13050
- Everclear 2-component colour adhesive, khaki Art. 13051
- Everclear 2-component colour adhesive, brown Art. 13052
- Everclear 2-component colour adhesive, brown Art. 13053
The Everclear 2-component colour adhesive can be easily applied using the 2-component skeleton gun Art. 12987. In addition, we recommend to use our mixing nozzle, 12 pieces Art. 12971.
Everclear 2-component colour adhesive - easy application in just a few steps:
- Ensure in advance that the surface is clean, dust-free, completely dry and roughened.
- Remove the cartridge cap and insert the cartridge into the 2-component joint gun.
- Press the handle of the joint gun until the material emerges from both openings.
- Unscrew the mixing nozzle, do not use the first 10 cm of the material in the mixing nozzle.
- At 20° C, the mixture can be used for approx. 20 minutes. The maximum strength is reached after approx. 48 hours at 20° C. You can accelerate the curing time by using heat.
Do you have any questions on this item?
